|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
citroenboixm
2CV Fan
Joined: August 24th, 2011, 12:45 pm
Posts: 32
|
 Suspension can nuts Hi guys,
Having real probs getting the suspension can off my chassis. Rear tie rod end is undone no probs but the trouble is the nut furthest from the can is loose and the one nearest is tight as. When I turn the nut with the spanner a the whole thing turns. I have tried tightening the front nut whilst trying to loosen the rear but getting no where.... Any suggestions?
Cheers mark
|
| July 30th, 2014, 5:24 pm |
|
|
|
AZS
Firing on two.
Joined: December 22nd, 2013, 5:01 am
Posts: 300
Location: Netherlands
|
Re: Suspension can nuts Aren't there any cutouts in the threaded bush? These you can use to put in a steel strip to prevent the bush from turning, while undoing the nut closest to the can.
WD 40, heat, hammering, etc. could also help to loosen things up.
|
| July 30th, 2014, 5:32 pm |
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 48 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|