
Are you sitting comfortably?
I hope to be fairly soon.
When I take my Charlie of the road next month for a darn good refurb, one of the things I plan to do is fit firmer seats - I just don't get on with the original softies. And yesterday, I collected the ones I plan to use...
They're from a Suzuki Vitara (not these actual ones, but similar:
http://cgi.ebay.co.uk/ws/eBayISAPI.dll? ... K:MEWAX:IT)
Why this car? Because (a) they look well lush, (b) they are
extremely comfy, and (c) - most importantly - they have rear seats that
should fit into a Deux Chevaux!
The rear seats are only 520mm wide, so should fit in nicely between the arches. Also, they fold flat, slide back and forth AND the whole seat tips completely forward - instant extra boot space
I haven't examined them closely yet, but it looks like the rears are fitted using hinges at the front of the rails (which should hopefully bolt through the front edge of the raised rear floor bulkhead) and then a retaining loop will need to be fixed on the floor at the back that the seats clip in to.
The front slide rails are uneven heights, so a frame will need making for them. But I believe that applies to
any seat you'd want to fit.
I just need to dust down my welder. And learn how to weld...
(Please check these measurements for yourselves before considering them...)