International2cvFriends.com
http://international2cvfriends.com/forum/

Genuine Tow Bar Bolts
http://international2cvfriends.com/forum/viewtopic.php?f=7&t=969		 Page 1 of 1
Author:  Tim2cv [ October 28th, 2009, 8:56 pm ]
Post subject:  Genuine Tow Bar Bolts
Right, question is, Do i use the existing axel tube bolts or should there be some longer ones avaliable? I ask as the thickness of the towbar reduced the amount of working thread through the axel tube locations?

I may have missed something obvious but please help to put my mind at rest!

cheers!
Author:  ken [ October 28th, 2009, 9:29 pm ]
Post subject:  Re: Genuine Tow Bar Bolts
Tim,
d'you remember that gearbox which donated an output shaft a while back?
Well, you may need to plunder some more off it, as the bolts holding the calipers on are an ideal length for fitting an original Citroen towbar to a chassis.
They're also the correct 10/9 grade, so should prevent your axle escaping... ;)

ken.

Tim2cv wrote:
Right, question is, Do i use the existing axel tube bolts or should there be some longer ones avaliable? I ask as the thickness of the towbar reduced the amount of working thread through the axel tube locations?

I may have missed something obvious but please help to put my mind at rest!

cheers!
Author:  Tim2cv [ October 28th, 2009, 10:25 pm ]
Post subject:  Re: Genuine Tow Bar Bolts
cheers Ken, Got the bits on the shelf next to Jeremy. I will swap them over next time I get him out on the drive.

thanks
Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/