| International2cvFriends.com http://international2cvfriends.com/forum/ |
|
| Used Pistons and Barrels http://international2cvfriends.com/forum/viewtopic.php?f=7&t=933 |
Page 1 of 1 |
| Author: | subarupete [ October 14th, 2009, 11:04 am ] |
| Post subject: | Used Pistons and Barrels |
Have a used set of pistons and barrels. There is no ridge on the barrels. What sort of tolerance is ok? Worth fitting new rings? |
|
| Author: | 2CViking [ October 14th, 2009, 11:36 am ] |
| Post subject: | Re: Used Pistons and Barrels |
Very simple. Fit new compression ring inside the worn barrel and measure the end gap max 0.35mm. If bigger then barrel is worn (out) I would bin it. |
|
| Author: | toomany2cvs [ October 14th, 2009, 2:59 pm ] |
| Post subject: | Re: Used Pistons and Barrels |
2CViking wrote: Very simple. Fit new compression ring inside the worn barrel and measure the end gap max 0.35mm. If bigger then barrel is worn (out) I would bin it. If it was even slightly worn, there'd be a ridge, though... |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|