International2cvFriends.com http://international2cvfriends.com/forum/ |
|
axle arm castellated nut - tightening it up. http://international2cvfriends.com/forum/viewtopic.php?f=7&t=6477 |
Page 1 of 1 |
Author: | sdelasal [ March 8th, 2024, 12:31 am ] |
Post subject: | axle arm castellated nut - tightening it up. |
Hello - I've been working on my axle arm bearings - I've changed out the old rusty ones, re-greased and am reassembling. Has anyone got a method for tightening up the castellated nut - the manual say tighten to 43ft.lb, back off, then tighten to 36ft.lb. I don't have a suitable socket - so am looking for something involving tapping the nut around with a drift. |
Author: | Geert [ March 8th, 2024, 8:40 am ] |
Post subject: | Re: axle arm castellated nut - tightening it up. |
Buy a torque spanner ! it always comes in handy . I have three of them, a small one, one with more torque and one with even more torque. Nowadays they are not that expensive. edit: Ups, i did not read it properly |
Author: | rob massey55 [ March 8th, 2024, 12:01 pm ] |
Post subject: | Re: axle arm castellated nut - tightening it up. |
Hi, if you've gone to the trouble of buying new bearings etc. then what's another £32.00 plus p&p for a lock ring tool? Seriously though, drifting it will work but if you are in the 2cvgb club then asking your local group to borrow one would be best. Good luck |
Author: | sdelasal [ March 9th, 2024, 2:39 am ] |
Post subject: | Re: axle arm castellated nut - tightening it up. |
ummm. The burton tool @£32, https://www.burton2cvparts.com/en/rolli ... cknut-tool, does not have a 1/2" female for a torque wrench! It just has 4 holes - for a screwdriver it says! No different to a drift. |
Author: | AZL57 [ March 9th, 2024, 11:51 am ] |
Post subject: | Re: axle arm castellated nut - tightening it up. |
Make something yourself with a few pieces of angle iron with an old socket welded on top?? |
Author: | rob massey55 [ March 10th, 2024, 12:51 am ] |
Post subject: | Re: axle arm castellated nut - tightening it up. |
I should have said that a suitable nut should be welded on top of the expensive tool. I made my own. IMG_2889 by Robndaisy, on Flickr IMG_2891 by Robndaisy, on Flickr |
Author: | sdelasal [ March 10th, 2024, 12:49 pm ] |
Post subject: | Re: axle arm castellated nut - tightening it up. |
Yes, lovely ... that's the answer. |
Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |