| International2cvFriends.com http://international2cvfriends.com/forum/ |
|
| Alternator id please http://international2cvfriends.com/forum/viewtopic.php?f=7&t=6140 |
Page 1 of 2 |
| Author: | Two Chevrons [ June 24th, 2018, 6:01 pm ] |
| Post subject: | Alternator id please |
Hi all got a few charging issues with my acadiane, s3ms when its warm it stops charging and tickover increases, if I take a live to to the battery from the exiter car on the alternator she starts charging pics of alternator and regulator as below Sam thinks possible visa alternator.   
|
|
| Author: | Two Chevrons [ June 24th, 2018, 6:02 pm ] |
| Post subject: | Re: Alternator id please |
Sorry for the repeated pics |
|
| Author: | Two Chevrons [ June 24th, 2018, 6:31 pm ] |
| Post subject: | Re: Alternator id please |
 This is my new acadiane does anyone recognise it |
|
| Author: | Two Chevrons [ June 24th, 2018, 6:32 pm ] |
| Post subject: | Re: Alternator id please |
Thanks in advance |
|
| Author: | Roger V [ June 24th, 2018, 7:27 pm ] |
| Post subject: | Re: Alternator id please |
Someone had a similar problem not to long ago. If I recall it was cured with new brushes. Heat expansion was breaking a contact. |
|
| Author: | Two Chevrons [ June 24th, 2018, 8:07 pm ] |
| Post subject: | Re: Alternator id please |
Thanks Roger worth a try, just need to source some now, we think she's a visa alternator |
|
| Author: | Roger V [ June 24th, 2018, 8:54 pm ] |
| Post subject: | Re: Alternator id please |
Take them out and take a look. 
|
|
| Author: | Two Chevrons [ June 24th, 2018, 11:36 pm ] |
| Post subject: | Re: Alternator id please |
I did that they look ok one is shorter than the other I did a resistance test on them when cold and was fine from the contact on the ring to the connector end |
|
| Author: | bobh [ June 25th, 2018, 7:46 am ] |
| Post subject: | Re: Alternator id please |
The exciter wire looks like it has a nasty kink in it a couple of inches from the alternator. Is the wire good ? |
|
| Author: | Two Chevrons [ June 25th, 2018, 8:46 am ] |
| Post subject: | Re: Alternator id please |
bobh wrote: The exciter wire looks like it has a nasty kink in it a couple of inches from the alternator. Is the wire good ? I'll check the resistance with a wiggle good spot! |
|
| Page 1 of 2 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|