| International2cvFriends.com http://international2cvfriends.com/forum/ |
|
| Driver Seat Problem http://international2cvfriends.com/forum/viewtopic.php?f=7&t=3217 |
Page 1 of 1 |
| Author: | ameletter [ August 9th, 2011, 7:18 am ] |
| Post subject: | Driver Seat Problem |
Got this 2cv from Switzerland, came in over Perth, got a problem with the driver seat, lefthand drive! It seams to hang in an angle horizontally AND linear to the outside and I never feel very comfty in it! Tried to bend it, foam wedges and longer screws, but it just seems wrong! Does anybody know about the problem? Were there different seats made for left and righthand side drives? I would appreciate any input! Ame from Australia |
|
| Author: | Sean [ August 9th, 2011, 8:14 am ] |
| Post subject: | Re: Driver Seat Problem |
Dont think there was any difference between RHD cars and LHD. As its by way of Switzerland it may be German spec seats which had the head restraints and possibly back adjustment? |
|
| Author: | ameletter [ August 9th, 2011, 8:22 am ] |
| Post subject: | Re: Driver Seat Problem |
nothing like that - they look like a pair, but in different angles! Don't know what it is - maybe an elephant drove the car once and bent the chair? But I measured all the angles ??? It's just toooo low on the door-side and bent outwards - what should make it easier to climb in and out! If you set it on the table it seems that the outside runner is shorter than the inside one with the catch! |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|