I've got all the pistons and barrels ect.. I'll find out about getting it sorted.
@ scooby pete my dad still wants them he keeps on about it, ring him up and remind him to do something about it
| International2cvFriends.com http://international2cvfriends.com/forum/ |
|
| Visa pistons and barrels on a 602 block http://international2cvfriends.com/forum/viewtopic.php?f=7&t=2929 |
Page 1 of 1 |
| Author: | Little Louis [ April 18th, 2011, 3:07 pm ] |
| Post subject: | Visa pistons and barrels on a 602 block |
what do i do with the push rod tubes, as the visa heads don't have them and are flat so wont fit? |
|
| Author: | subarupete [ April 18th, 2011, 3:50 pm ] |
| Post subject: | Re: Visa pistons and barrels on a 602 block |
Loius, The crankcase (halves) needs to be machined flat, IMO. What's happening about longer springs on Gertrude? Peter |
|
| Author: | Sean [ April 18th, 2011, 3:57 pm ] |
| Post subject: | Re: Visa pistons and barrels on a 602 block |
you need visa heads if you want that, but you need to weld up and face the block where the push rod tubes seals seat. Or its 602 heads with barrels taken out to take the pistons. |
|
| Author: | Little Louis [ April 18th, 2011, 7:16 pm ] |
| Post subject: | Re: Visa pistons and barrels on a 602 block |
I've got all the pistons and barrels ect.. I'll find out about getting it sorted. @ scooby pete my dad still wants them he keeps on about it, ring him up and remind him to do something about it
|
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|