| International2cvFriends.com http://international2cvfriends.com/forum/ |
|
| Gear lever bush http://international2cvfriends.com/forum/viewtopic.php?f=7&t=2618 |
Page 1 of 1 |
| Author: | 2CViking [ January 20th, 2011, 3:43 pm ] |
| Post subject: | Gear lever bush |
How to? Seen and tried some options. None any good really. I now cut, replace the bushes and weld it again. Heard of an englishman doing this without cutting. Do you know the secret? Attachment: lever-002.jpg Attachment: lever-001.jpg |
|
| Author: | J-dub [ January 21st, 2011, 1:23 am ] |
| Post subject: | Re: Gear lever bush |
make a pattern of it / mould, heat it up, bend, remove, replace bushes, push back through, re bend to mould / pattern? if life was only so simple |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|