Well ....!!!
I have ordered new wiper shafts home when the old ones were leaking and the water was pissing in when it rains.
This little project I thought I would enjoy myself with in the Christmas holidays, but no!
The axles I had ordered, is for 2CV and one would think they were the same at Dyan, but they are not.
As you can see in the pictures, the two pull rods are not parallel, meaning that the right window wiper, is running the wiper off the windshield and beyond the A pillar. (original shafts top, new shafts below)
The reason is that the middle piece on the shaft, is not S-shaped and is also a bit shorter.
Do any of you know if shafts fore Dyane still are available?
Alternatively, the solution must be to cut the rods and extend them or do you have other suggestions?
