| International2cvFriends.com http://international2cvfriends.com/forum/ |
|
| indicator stalk and wiring http://international2cvfriends.com/forum/viewtopic.php?f=7&t=2113 |
Page 1 of 1 |
| Author: | meshking [ August 26th, 2010, 9:01 pm ] |
| Post subject: | indicator stalk and wiring |
Hi, Two questions tonight which I could probably answer if I hadn't loaned my 2cv to a friend: - what holds the indicator switch to the steering column? - anyone happen to know the colour codes for the wiring loom connections between rear wiring and the loom itself in the engine bay (on the bulkhead)? I couldn't find any useful colours in the haynes - this is for my 1975 car, in case it makes a difference. Thanks! Ben |
|
| Author: | meshking [ August 26th, 2010, 9:07 pm ] |
| Post subject: | Re: indicator stalk and wiring |
oops, cancel the second question. It's in the 2cvgb handbook, and a very useful fellow's photostream on flickr (thanks Ken, that's twice your photostream has come in useful in 24 hrs!) |
|
| Author: | Nelsthebass [ August 26th, 2010, 9:48 pm ] |
| Post subject: | Re: indicator stalk and wiring |
It sits on a bit of steel bracket that slides up inside the switch near to the steering column end - the bracket is held on to the column via the lighting switch assembly.... |
|
| Author: | meshking [ August 26th, 2010, 9:57 pm ] |
| Post subject: | Re: indicator stalk and wiring |
Ah - that confirms my thoughts then - I've lost another bit! Thanks very much |
|
| Author: | J-dub [ August 27th, 2010, 9:34 am ] |
| Post subject: | Re: indicator stalk and wiring |
Nelsthebass wrote: It sits on a bit of steel bracket that slides up inside the switch near to the steering column end - the bracket is held on to the column via the lighting switch assembly.... it tends to slide of at the worst times too!! |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|