petrol and a match
don't use methanol tho 
| International2cvFriends.com http://international2cvfriends.com/forum/ |
|
| Black coating on panels http://international2cvfriends.com/forum/viewtopic.php?f=7&t=1890 |
Page 1 of 2 |
| Author: | Norman [ June 29th, 2010, 3:57 pm ] |
| Post subject: | Black coating on panels |
Whats the best way to remove the black coating from new panels? Does it all need to be removed? Inside and Out? Thanks |
|
| Author: | tarquin slough2cv [ June 29th, 2010, 4:46 pm ] |
| Post subject: | Re: Black coating on panels |
nitromors paint stripper a metal scouring pad is what we use. depends on which panels it is about both sides or not petrsonally we strip both sides back to bare metal for the best paint job |
|
| Author: | ginger bloke [ June 29th, 2010, 4:53 pm ] |
| Post subject: | Re: Black coating on panels |
petrol and a match don't use methanol tho
|
|
| Author: | 2CViking [ June 29th, 2010, 5:15 pm ] |
| Post subject: | Re: Black coating on panels |
Norman wrote: Does it all need to be removed? Thanks No 
|
|
| Author: | Lenny [ June 29th, 2010, 5:17 pm ] |
| Post subject: | Re: Black coating on panels |
I've never bothered removing it personally. Never had any trouble. |
|
| Author: | grifftravel [ June 29th, 2010, 5:47 pm ] |
| Post subject: | Re: Black coating on panels |
ginger bloke wrote: petrol and a match don't use methanol tho can't believe you said that Fireman Graham, about the methanol that is
|
|
| Author: | ginger bloke [ June 29th, 2010, 6:52 pm ] |
| Post subject: | Re: Black coating on panels |
there isn't an emoticon with tongue firmly in cheek 
|
|
| Author: | Norman [ June 30th, 2010, 3:34 pm ] |
| Post subject: | Re: Black coating on panels |
ginger bloke wrote: petrol and a match don't use methanol tho Off topic its healing up quite well |
|
| Author: | ginger bloke [ June 30th, 2010, 4:01 pm ] |
| Post subject: | Re: Black coating on panels |
good 
|
|
| Author: | Roy Eastwood [ June 30th, 2010, 8:28 pm ] |
| Post subject: | Re: Black coating on panels |
If it's a black left wing for AK, then all off - otherwise it will lift later, taking your final finish with it, presenting bare metal for the rust bug to eat! Norman wrote: Whats the best way to remove the black coating from new panels? Does it all need to be removed? Inside and Out? Thanks |
|
| Page 1 of 2 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|