| International2cvFriends.com http://international2cvfriends.com/forum/ |
|
| Wanted: Spare Wheel cover 'latch mechanism' http://international2cvfriends.com/forum/viewtopic.php?f=7&t=1815 |
Page 1 of 1 |
| Author: | Norman [ June 8th, 2010, 11:19 am ] |
| Post subject: | Wanted: Spare Wheel cover 'latch mechanism' |
I am missing one of the 2 latch mechanisms that are part of the spare wheel cover for a AKS400. It is made of the latch bar itself, a spring and the operating bar that protrouded out of the panel. A possible replacement would be the one used on an acadiane or the acadiane vans had a load retaining panel behind the front seat that is secured using the same mechanism. I had one of these on my Acadiane but it was never used. So if you have one of these surplus let me know. If any one has one of these or know where I can buy one that would be a help. As we start to rebuild the van I'm sure this wont be the only bit that is missing! Any help greatly appreciated. |
|
| Author: | toomany2cvs [ June 8th, 2010, 1:23 pm ] |
| Post subject: | Re: Wanted: Spare Wheel cover 'latch mechanism' |
Norman wrote: or the acadiane vans had a load retaining panel behind the front seat that is secured using the same mechanism. It wasn't on ours - it was just two bolts and two pins. The latches are little buggers for going awol - the Acad's flap was tie-wrapped closed... |
|
| Author: | tarquin slough2cv [ June 9th, 2010, 10:18 am ] |
| Post subject: | Re: Wanted: Spare Wheel cover 'latch mechanism' |
Think i have spare 1, i'll have a look and see what i got. |
|
| Page 1 of 1 | All times are UTC + 1 hour [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|