International2cvFriends.com
http://international2cvfriends.com/forum/

602 inlet/ exhaust manifold
http://international2cvfriends.com/forum/viewtopic.php?f=7&t=1538		 Page 1 of 1
Author:  wiltz [ March 30th, 2010, 7:22 pm ]
Post subject:  602 inlet/ exhaust manifold
I'm wondering if a standard 602 manifold will fit onto a 652 visa Engine?

I'm fancying the long time log jamed in the shed, but started up on a pallet on sunday 652 engine, spending a summer in the Acad. During the casual poke/look around we noticed a small section of rubber pipe jubilee clipped up on one of the inlet pipes close up to the carb mounting block, i'm not aware this was a problem when we ran the Visa, but looks as though it could be a temporary repair done by a previous owner. As I have got a really good 602 manifold, I wondered if this would be a straight swop?
If not I'll leave well alone, and put it in as it is and look for another. :)
Author:  ken [ March 30th, 2010, 7:59 pm ]
Post subject:  Re: 602 inlet/ exhaust manifold
wiltz,
if it makes life any easier, all Visa 2 pot manifolds are like that... :lol:

ken


wiltz wrote:
I'm wondering if a standard 602 manifold will fit onto a 652 visa Engine?

I'm fancying the long time log jamed in the shed, but started up on a pallet on sunday 652 engine, spending a summer in the Acad. During the casual poke/look around we noticed a small section of rubber pipe jubilee clipped up on one of the inlet pipes close up to the carb mounting block, i'm not aware this was a problem when we ran the Visa, but looks as though it could be a temporary repair done by a previous owner. As I have got a really good 602 manifold, I wondered if this would be a straight swop?
If not I'll leave well alone, and put it in as it is and look for another. :)
Author:  grifftravel [ March 30th, 2010, 8:58 pm ]
Post subject:  Re: 602 inlet/ exhaust manifold
Remember to change the clutch on it Wiltz if its the same engine I think it is.
Author:  wiltz [ March 30th, 2010, 10:45 pm ]
Post subject:  Re: 602 inlet/ exhaust manifold
ken wrote:
wiltz,
if it makes life any easier, all Visa 2 pot manifolds are like that... :lol:

ken


Thanks Ken, it just looks home made.
Author:  wiltz [ March 30th, 2010, 10:50 pm ]
Post subject:  Re: 602 inlet/ exhaust manifold
grifftravel wrote:
Remember to change the clutch on it Wiltz if its the same engine I think it is.


Yes Paul I bet you can still smell it, I did put a clutch in the following week,we ran the car for a few more months after that, but then it got the chop for want of a clutch cable, sad really. :lol:
Author:  wiltz [ March 30th, 2010, 11:22 pm ]
Post subject:  Re: 602 inlet/ exhaust manifold
Yes Ken I've( or rather Annie's) found it, page 80 photo 7.3 Haynes Visa manual. :lol:
Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/