International2cvFriends.com
http://international2cvfriends.com/forum/

Washer pump inlet/outlet
http://international2cvfriends.com/forum/viewtopic.php?f=7&t=1376		 Page 1 of 1
Author:  Old-Nail [ February 23rd, 2010, 4:52 pm ]
Post subject:  Washer pump inlet/outlet
I've only just noticed that the two prongs on the back of the windscreen washer pump are different. One is taller and the other has a bigger hole. Anyone know which is the inlet of those two before I take a 50-50 guess... and lose ;)
Author:  Little Louis [ February 23rd, 2010, 6:18 pm ]
Post subject:  Re: Washer pump inlet/outlet
pump it with your finger over one of the holes and see if one of them sucks?
Author:  PeteMcFlurry [ February 23rd, 2010, 6:31 pm ]
Post subject:  Re: Washer pump inlet/outlet
well i'd guess the one with the bigger hole would be the inlet, taking x volume in at low pressure, pumping it through a smaller hole making it higher pressure?
Author:  bertiewhite [ February 23rd, 2010, 6:39 pm ]
Post subject:  Re: Washer pump inlet/outlet
I was going to say - I stuck some bits of tubes on mine and tried each in a jar of water.
Author:  Old-Nail [ February 23rd, 2010, 7:16 pm ]
Post subject:  Re: Washer pump inlet/outlet
PeteMcFlurry wrote:
well i'd guess the one with the bigger hole would be the inlet, taking x volume in at low pressure, pumping it through a smaller hole making it higher pressure?


I'll go with that thanks.
Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/