I'm nearly there (I think) with the wiring on my car now and I've dug out and connected up the turn signal and high beam wiring too, can someone please ID which is the correct wire to connect to the brake test terminal shown in the photo below?
I took a photo of the wiring before I undid it, and I labelled most of it too so I'm pretty confident that most of it is where it should be, but I've still finished up with two wires and only one connection left!
This is the view from another angle if that's any better.
And this is how it looked when I first undid it. Any ideas?
Both the wires I have 'left over' are purple female connectors, one on green wire one on grey.