|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Windscreen panel replacement
| Author |
Message |
|
Darvie43
Joined: April 22nd, 2009, 9:37 am
Posts: 1
|
 Windscreen panel replacement I have bought a new windscreen panel,drilled out the old spot welds and removed the old rusty panel.
A freind has oxy,tig and mig,what would be the best way to attach the new panel,the sides concern me the most.
Darvie
|
| April 30th, 2011, 6:37 am |
|
|
|
Russell
Firing on two.
Joined: November 29th, 2008, 10:05 pm
Posts: 9259
Location: West Sussex, U.K.
|
Re: Windscreen panel replacement Drill out some neat 5mm holes where the spotwelds were on the panel you removed and plug them with mig weld. You're better off doing it with a spotwelder though. If he's a wizard with the tig then that might be a neater option.
_________________
samfieldhouse wrote: What I like about I2F is that there is no pretence of democracy.
|
| April 30th, 2011, 7:35 am |
|
|
|
Sean
Firing on two.
Joined: April 22nd, 2009, 11:06 pm
Posts: 3684
Location: Ecosse
|
Re: Windscreen panel replacement and you can cut a cheap clamp so it fits in the slotted holes to get it all tight  
_________________
Kissing the Lash
"Any advice of a technical nature is given on the understanding that I've actually done this shit, not just read about it in D*lly club mag some time ago.
|
| April 30th, 2011, 8:11 am |
|
|
|
|
Page 1 of 1
|
[ 3 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 49 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
