International2cvFriends.com
http://international2cvfriends.com/forum/

Cheap rev counter that works with 2cv with 123 ignition
http://international2cvfriends.com/forum/viewtopic.php?f=4&t=3827		 Page 1 of 1
Author:  ChrisW [ April 2nd, 2012, 5:56 pm ]
Post subject:  Cheap rev counter that works with 2cv with 123 ignition
Found this on ebay and bought it on the understanding if it does not work could return it for refund. But hey presto works fine even with 123 evo ignition.
People very helpful.


http://www.ebay.co.uk/itm/370594104494? ... 1497.l2649
Author:  Sean [ April 2nd, 2012, 6:01 pm ]
Post subject:  Re: Cheap rev counter that works with 2cv with 123 ignition
you did tell them it was a 2cv with a "lost spark" ignition - same as a HD
Author:  ChrisW [ April 2nd, 2012, 6:13 pm ]
Post subject:  Re: Cheap rev counter that works with 2cv with 123 ignition
Yep - but they were not sure it would work but no problems. Running up without shakes etc and good finish on the thing
Author:  J-dub [ April 2nd, 2012, 6:50 pm ]
Post subject:  Re: Cheap rev counter that works with 2cv with 123 ignition
So this is a silly question
Will it work with standard set up
Author:  Taskos [ April 2nd, 2012, 7:16 pm ]
Post subject:  Re: Cheap rev counter that works with 2cv with 123 ignition
I bought a cheap tacho suitable for typical 4-cyl 4 stroke engine, 1 year ago and works since.
The signal connection is on the coil.

:idea: The lost spark is not a problem as is the same sparks/revolutions rate as a 4-cyl.
Author:  ChrisW [ April 2nd, 2012, 7:31 pm ]
Post subject:  Re: Cheap rev counter that works with 2cv with 123 ignition
Hi Jameswallace,
I should it would be fine. 123 only gives a signal as per the points
Page 1 of 1 All times are UTC + 1 hour [ DST ]
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/